T56 manual transmission fluid
It's easily correctable before the transmission is installed.
On 6/23/2015 I am still building the car this is going in, but it is a Tremec.
Yeah, I plan on running the Valvoline Dex III from Walmart if the price is right on it, filter wise I run Microguard (O'Reillys house brand made by Wix) on my daily driver now and bartender label printing software crack Mobil 1 On my LT1 since the micron level.This transmission should be your only consideration if doing.0L Coyote swap in your Mustang!Compared to my old t5, this t56 has what seems to be a much tighter linkage causing my shift time to become greatly reduced and no more leaning forward for 5th gear because its as easy to hit as 3rd gear.Classic Chevy 5-Speed uses a brand new Tremec T56 transmission, McLeod clutch components, custom-made Inland Empire Driveline driveshafts, and other GM parts.Heaven on a stick.11/17, with the transmission bolts tight, lift the transmission up high enough to remove the jack under the oil pan.This is very rare, but important to check.
2007 Corvette C6 Z06 T56 Manual Transmission Torque Tube Wiring Harness 149.00, buy It Now or Best Offer, free Shipping.
(At this point, it is important to check Classic Chevy's supplemental instructions for proper master cylinder clutch pedal pushrod-to-clutch pedal adjustment.) Using a 5/64-inch drill bit, drill a hole and tap it with a 1/4-inch x 28-thread tap.
Even though the T56 was designed to fit behind LS motors, it really can fit almost any Chevrolet.
The input shaft carries 26 splines and the output shaft is 31 spline.
No matter what you do with your Mustang, this Tremec T56 transmission will likely handle it!
Free via UPS Truck Freight shipping!3/17, before installing your transmission, attach your shift handle to the shift stub and make sure that the shifter can be moved into all gears properly.Remove the shifter and set it aside.12/17, now it's time to climb back inside the car inside and install the shifter mechanism to the transmission using RTV sealant.From underneath the car, drill small pilot holes on each corner of the shifter outline that you drew.On 11/8/2014 make sure to call tremec after you order and before the install.